Spearhead DESTROYER
17
17
17
17
Slip Clutch Maintenance & Settings
Slip Clutch Maintenance & Settings
Slip Clutch Maintenance & Settings
Slip Clutch Maintenance & Settings
The compression of the Belleville spring used on this friction clutch must be adjusted to
compensate for wear of the linings and to maintain the desired setting.
Check the condition of the friction discs before use and following periods of storage, if
they need freeing. Release the tension from the spring and turn the clutch while holding
the PTO stationary. Re-adjust the spring compression to the original setting.
Following seasonal use, unlock the spring tension and store clutch assembly in a dry
place. Check condition of friction linings and reset spring compression to original height
before use.
Should the assembly overheat due to frequent or prolonged clutch slipping, dismantle
for inspection. The original thickness of the lining is 3.2mm, replace them when worm
to 2.5mm. Clean up all contact surfaces and replace any damaged components before
assembly.
Note
Note
Note
Note
Friction clutches may become hot. DO NOT TOUCH
Fig No.
Position
Part No.
Setting
Machine
2 (h)
Centre
5770528
20.1mm
Destroyer (1000rpm)
