Spearhead 9561210, Руководство пользователя

Страница: 36 / 46

8999070: v3 03/09/2018
Page 6.8 of 6.10 pages Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
If replacing the blades, remove the retaining bolt (1) and nut (3) and dismantle the blade (2) and bush (4).
Replace the blade (2) and/or the bush (4) and reassemble to the carrier (5) with a new nut (3) and bolt (1).
Tighten the retaining bolt (1) and nut (3)
. Refer to ‘Specific Torque Settings’; Section 6.14.
6.10 Deck suspension adjustment
Figure 6.11 Figure 6.12
Figure 6.13
Attach Topper to Tractor, and lift clear off the ground, allowing deck to pivot freely; see Figure 6.11.
Remove PTO shaft between gearbox and deck.
Slacken Spring Assembly at the Lock nuts above and below the arm.
Adjust bottom lock nut position to a distance of 50mm measured from the shank of the ball joint to the
underside of the locknut; see Figure 6.12. Tighten the lock nut.
Adjust top lock nut position to a distance of 25mm measured from the end of thread to the first lock nut; see
Figure 6.13. Tighten lock nut.