8999071EN: v1.410/10/2019
23
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
After every 8 hours always check:
8.5.1.2
If the nuts are tightened enough,
A wear and condition of working tools,
Belts and taper locks,
A condition of safe guards,
Oil level in the gearbox,
That any foreign parts are not stuck on the rotor shaft,
That the frame and the 3-point hitch are in good condition,
That all parts are greased well.
On every 100 hours we recommend to:
8.5.1.3
Check and grease the PTO shaft
On every 12 months we recommend to:
8.5.1.4
Change the oil in the gearbox and check the belts tension.
8.6
Replacement Of Flails
Immediately after you notice that flails are damaged, change them. If it is necessary to change only few flails,
always change the broken or worn one and the one diametrically opposite in order to maintain the balance. If the
rotor shaft is vibrating after changing the blades, immediately stop the machine. The machine must be balanced
before any work.
Figure 42
8.7
At The End Of The Season
At the end of the season we recommend to clean the complete machine, change eventual broken or worn parts,
tighten the bolts, the belts, grease the parts and oil the parts with damaged colour. Put the machine on a dry and
flat ground.
8.8
Disposal
If the machine is out of order, all its parts that might cause dangers have to be made inoffensive. Materials,
forming the machine that has to undergo a differentiated division, are:
Steel, mineral oil, rubber, plastic
All the above mentioned operations and the disposal have to be carried out in total respect of the present
provisions of law on the subject.
