CLUB LED INSTALLATION INSTRUCTIONS
WASTE DIRECTIVE
IMPORTANT WARNINGS
The European Directive 2002/96/EC on waste electrical and electronic
equipment requires that electric and electronic devices must not be
disposed of in the normal household waste. For correct disposal, please use
authorized waste disposal facilities or return to the distributor at the date a
new lighting fitting is purchased. Lamps, if disposed together with the
lighting fitting, should not be broken up as they contain pollutants, which
are harmful to the environment. Unauthorized disposal of the foregoing
waste material is punishable by law.
Spear Lighting Ltd, Unit 8 Cowley Mill Trading Estate, Longbridge Way, Uxbridge, Middlesex, UB8 2YG
Tel: 01895 746006 E-Mail:
www.spearlighting.com
Do not install the luminaire in areas without sufficient
air circulation.
The manufacturer cannot be considered liable for any
damage caused by inappropriate use of the luminaire
other than its manufactured purpose.
Luminaries must be installed by a qualified registered
electrician only.
Any misuse of the luminaire when power is activated
may cause the risk of an electric shock.
The manufacturer does not accept any responsibility of
any issues resulting from the non-compliance of the
recommendations included in this instruction
document. These instructions are issued as a guide to
assist the installer to satisfactory conclusion.
The manufacturer reserves the right to change the
design of this product without prior notice.
d)
The floodlight is already internally wired and needs to be connected to the mains via an external fast
connector. A H05RN-F rubber cable or equivalent is recommended. If the power cord is damaged it
must be replaced by qualified personnel (Fig. 4 & 5).
e)
Connect wires to the terminal block as indicated in Fig. 6.
f)
Before entering the wiring compartment be sure to unplug the power mains and remove the two
screws located between the dissipation fins with special Allen tool (Fig. 7).
g)
To close the floodlight, release the block spring (Fig. 8).
To remove the power supply:
h) Disconnect the two power cables (Fig. 9).
i)
Loosen the screws and rotate the retention tabs (Fig. 10).
4
5
6
7
8
9
10