AFTER SALES HELPLINE
0345 605 2068
19
OPERATE
Mowing tips
i. Verify that the lawn is free of stones, sticks, wires ,and other
objects that could damage the hover.
ii. When cutting thick grass, reduce walking speed in order to
allow for a more effective cut and a proper discharge of the
clippings.
iii. Never cut off more than one-third of the total length of the
grass for a healthy lawn. If it is roughly 6cm long, the grass
should not be shorter than 4cm once mowed. If the grass
is higher, you should gradually cut it down to the desired
length so as not to damage the grass.
iv. Do not cut wet grass because it tends to stick to the un-
derbody of the hover, preventing the proper discharge of
grass clippings.
Blade Maintenance
Always switch the product off, disconnect it from power sup-
ply and let the product cool
down before performing inspection, maintenance and clean-
ing work!
Removing the blade and fan. USE GLOVES.
• To remove the blade bolt
18
, hold the blade
19
firmly and
with the spanner
10
provided loosen the blade bolt
18
.
• Remove the blade bolt
18
, blade
19
, spacer
20
and
impeller
21
.
• Inspect for damage and clean as necessary.
Renew your metal blade after 50 hours mowing or 2 years
whichever is the sooner-regardless of condition. If the blade is
cracked or damaged replace it with a new one. Never use a
blade bolt if the insulated head is damaged cracked or missing.
Fitting the blade and impeller. USE GLOVES.
• Ensure the impeller
21
is located correctly.
• Place the spacers
20
onto the fan ensuring the pegs have
located into the holes
• Ensure the pegs have located into the holes on the blade
and that the blade is positioned as illustrated in figure 6.
• Place the blade bolt
18
through the centre hole of the
blade.
• Tighten down clockwise by hand.
• Hold the blade
19
firmly and tighten the blade bolt with
the spanner provided.
33 mm
12 mm
19 mm
26 mm
21
19
18
20
