12
Align the UNLOCK Symbol of the Soap Bottle to
the Vertical Line on the Control Box. Press
upwards for engagement and rotate clockwise
until the LOCK symbol of the Soap Bottle is
aligned to the vertical line on the Control Box.
13
Select the proper Mode of the Sensor Soap
Dispenser based on the soap filled. The Mode
Switch button is located on the left side of the
Control Box.
FOAM
FOAM
SOAP
SOAP
LIQUID
LIQUID
SOAP
SOAP
FILL/REFILLING SOAP
14
Make electrical connections from the Sensor Eye to the Control Box. Connect the Blue Male Ended Wire to the
Blue Female Connection. Connect the Green Male Ended Wire to the Green Female Connection. To further aid
proper alignment, there are white alignment lines on the connector ends. These alignment lines should face
forward when properly installed.
GREEN
BLUE
15
FOR
BATTERY
POWER
•
Access the interior Battery Enclosure by unscrewing the two (X2) Screws
using a Phillips Screwdriver
(1).
• Insert or replace the batteries with four (X4) new standard 1.5v D size batteries. Ensure the position of the
new batteries are aligned to the plus (+) and minus (-) symbols within the battery holder (2).
BATTERIES NOT INCLUDED
16
FOR
BATTERY
POWER
• Close the Battery Box by tightening the two (X2) Philips screws. Determine the desired location of the Battery
Box, make sure the Connecting Wire is long enough to reach the Control Box. Mount the Control Box onto the
previously marked location using a Phillips Screwdriver and two (X2) Mounting screws (included) (1). If
mounting on drywall and not to stud, use the appropriate anchors and fasteners for application. Recommend
screw in EZ anchor or equal for drywall.
• Connect the Blue Battery Connector to the Blue Male Connector on the side of the Control Box (2).
45" MAX
WIRE L
ENGTH
BLUE
17
FOR A/C POWER
Disconnect and remove the Battery Box.
Connect the A/C Adapter
(included) to the Black Female Port on the
Control Box
. Plug the A/C Adapter into the wall outlet.
BLACK
18
For first time use, or after soap refill, activate the Sensor Soap Dispenser repeatedly to prime the pump. It may
take approximately 10-30 activations (depending on tube length) to get the pump primed. Check to make sure
that there are no leaks.
10-30
ACTIVATIONS
VIEW FROM UNDERNEATH
SENSOR EYE
