INSTRUCTIONS FOR MODELS
92-SFS-8000-01
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
www.speakman.com
SFS-8000
Classic Sensor Soap Dispenser
SFS-9000
Designer Sensor Soap Dispenser
HELPFUL TOOLS & SUPPLIES:
TOOLS AND SUPPLIES
Adjustable
Wrench
Safety
Glasses
Liquid
Soap
Foam
Soap
Pencil
Extended Phillips
Screwdriver
Drill
Scissors
Warranty information can be found at:
www.speakman.com
WARRANTY
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
FINISH MAINTENANCE
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Pay special
attention to the nozzle area. Periodically clean the
nozzle area to avoid soap residue build up. The use of
harsh chemicals and abrasives may damage the finish
and void the product warranty. Please be sure to only
use approved cleaners. Please contact Speakman for any
clarification of acceptable cleaners.
• This installation manual covers several models.
While the appearance of your model may vary, the
installation steps required are the same as shown in
this manual.
1
Remove the Rubber Washer (1), Metal Washer
(2) and Mounting Nut (3) from the threaded
Shank.
2
Verify that the Rubber Gasket is in position and
aligned to the base of the Faucet.
3
Place all hoses, sensor wire and threaded shank
through the mounting hole one at a time. Take
extra precautions to avoid pinching any wires.
Lower Sensor Soap Dispenser into position.
4
OR
From beneath, reinstall the Rubber Washer (1),
Metal Washer (2) and Mounting Nut (3) to
secure the Sensor Soap Dispenser. Align the
Sensor Soap Dispenser to desired position and
wrench tighten Mounting Nut (3). Verify that the
wires are not pinched.
5
Place the Control Box (1) against the desired mounting surface while ensuring adequate
clearance for servicing of all connections. If using the optional A/C Adapter, consider the
distance to the nearest electrical outlet. Control Box should be mounted so the Soap and Air
Outlet Ports are facing up.
14" MAX
IN ALL
DIRECTI
ONS
OPTIONAL AC ADAPTER
6
Mark Screw Hole mounting locations (X4) using a Mounting Screw
(included) and an extended Phillips Screw Driver. Mount the Control
Box onto the previously marked locations. If mounting on drywall and
not to stud, use the appropriate anchors and fasteners for
application. Recommend screw in EZ anchor or equal for drywall.
X
X
X
X
7
Align the SOAP and AIR tubes to the Control
Box. Cut to length and press tubing over barbed
fittings on Control Box.
AIR
SOAP
WARNING:
Running excessive tubing may lead to decrease
in performance. Always keep tube length to minimum.
8
Open the Soap Bottle Lid by pulling the
C Clip away.
9
Lift the Cap to access soap bottle.
10
Pour Soap into the Soap Container. This Soap
Dispenser will work with both Liquid Hand Soap
and Foaming Hand Soap with a viscosity
of < 2000cP.
LIQUID
OR
FOAM
11
• After filling the soap bottle, align the cutout of
the cap and close the bottle cap. Make sure the
feed tube reaches all the way to the bottom of the
bottle.
• Secure the Cap with the C Clip.
FILL/REFILLING SOAP
