13
#ONTROL/UTPUT
The 12V output jack on the back of the amplifier can be used
to turn on a variety of components equipped to be activated
when they receive a 12V DC output. Voltage is only delivered
to the jack when the amplifier is “on” or active. When the
amplifier turns off, the voltage ceases.
Before connecting another device to the 12 output please
make sure that the device can accept 12V DC at 150ma. To
connect the output to another device you must access the
output jack with a two-conductor plug that fits into the 2.5mm
jack. Be aware that the tip of the plug will be (+). If you are
unsure about using this feature please contact an authorized
SpeakerCraft dealer for assistance.
#ONNECTINGTHE3PEAKER7IRES
CAUTION: Only make connections when the amplifier is
turned off.
5SING3TANDARD#ONNECTIONS3EE$IAGRAM
For best performance use high quality speaker cables. The
banana plug outputs on the back of the amplifier allow
for a variety of ways to connect your speakers to the
amplifier.
$IAGRAM"INDING0OST$ETAIL
3ELECTING)NPUTS3EE$IAGRAMS
Each channel is capable of delivering the source from many
inputs. The three main inputs are BUS, AUX and LINE IN.
The selection for these inputs is done via the Input Selection
switch, marked “BUS-AUX-LINE”. To select a source for each
channel, follow the steps below:
1. Select the desired source input. Set the Input Selection
switch to BUS (will play source connected to the
BUS INPUT), AUX (will play source connected to the
AUX INPUT) or LINE (will play source connected to the
LINE IN).
2. The BUS and AUX inputs each have a left and right input.
The left, right or combined left and right signal from these
may be selected via the switch marked “R R+L L”. Select
the side you want the channel to deliver. Selecting “R” will
play the right channel of the selected input. Selecting “L”
will play the left channel of the selected input. Selecting
“R+L” will play the combined signals of right and left.
3ELECTING"RIDGE-ODE3EE$IAGRAM
It is sometimes desirable to combine two channels into one
through bridging. The output of the combined channels can
then be used to power one speaker.
To bridge two adjacent channels move the switch marked
“BRIDGE” to the “ON” position.
The speaker must be connected to the terminals immediately
under the “BRIDGED” text as indicated in
Diagram 11
. All
input selection and settings for the bridged channels will be
done on the channel to the left.
Do not connect more than one speaker to the outputs of the
bridged channel.
Diagram 10
Diagram 9
(+) (-)
Wires to Speaker
Diagram 11
To “ON” Position
