24
www.SpeakerCraft.com
INSTALLATION
SETTING ThE TURN-ON
mOdE SwITCh
The SC12-30 has three turn-on modes. Select
the mode you want by sliding the mode switch.
See Installation Considerations on page 16 for
more information about each of the turn-on
modes.
ThE CONTROL OUTpUT
This terminal provides a 12V DC signal
suitable for triggering SpeakerCraft
automated switchers, some motorized
screens, some electric curtain controls,
etc. This voltage is present only when the
amplifier is active or on. When the amplifier
turns off, the 12V signal is off.
TURN ON MODE
AUDIO SENSE
CONSTANT
3-30V
AC/DC
TRIGGER
INPUT
SliDe The SwiTch wiTh eiTher
your FinGernail or 1/8”
SloTTeD ScrewDriVer blaDe
STEp
DESCrIpTIon
1. check the requirements of the device you
want to control.
The control output has a maximum
current capability of 150 ma.
2. connect the 3.5 mm Jack to the control
output maintaining proper polarity
(tip = +).
TIP:
To conserve energy set the TURN ON mode to
either AUDIO SENSE or TRIGGER INPUT. Use of the
CONSTANT mode will prevent the amplifier from
turning off when not in use wasting energy.
Содержание SC12-30
Страница 1: ...SC12 30 Multi Channel Amplifier installation guide...
Страница 33: ...Blank no page no print...
Страница 35: ...P N 10001834 Rev A 09 2014...