ACOUSTACEll™ INSTAllATION
The AcoustaCell
™
System is an integral part of the performance of the MT8. It dampens
the wall cavity and improves the performance of the MT8. Installation can be easily
done at the time you are ready to mount the MT8 speakers.
1.
Remove any insulation materials from the wall cavity so that there will be room for
the AcoustaCell
™
System. Ideally you should have 44", centered top to bottom, clear
for installation of AcoustaCell
™
. With the area cleared of insulation, you are now
ready to install the AcoustaCell
™
System.
2.
Compress the lower AcoustaCell
™
segment so that it is small enough to fit through
the opening
(See Figure 7a)
and place it down into the opening. If you have
previously installed the MT8 InstaLLock
™
New Construction Bracket, slowly push the
AcoustaCell
™
down until it is stopped by the AcoustaCell
™
wing. If no bracket is in
place, slowly move the AcoustaCell
™
down until with a rule you measure 5
1
⁄
8
" from
the top of the AcoustaCell
™
to the bottom edge of the cut-out opening.
3.
Compress the upper AcoustaCell
™
segment and place it up into the opening.
(See
Figure 7a)
If you have previously installed the MT8 InstaLLock
™
New Construction
Bracket, slowly push the AcoustaCell
™
up until it is stopped by the AcoustaCell
™
wing.
If no bracket is in place, slowly move the AcoustaCell
™
up until with a rule you
measure 3
3
⁄
4
" from the bottom of the AcoustaCell
™
to the top edge of the cut-out
opening.
4.
Compress the center chamber and place it into the opening so that it is caught
between the upper and lower segments.
(See Figure 7b)
5.
The last step is to place the center wall sheet into the chamber opening by
removing the adhesive and placing against the back wall.
(See Figure 7c)
6.
For best results, the speaker wire should be routed behind the AcoustaCell
™
and
should enter the center AcoustaCell
™
chamber from directly above or below the
chamber.
(See Figure 8)
7.
You are now ready for installation of the MT8 speakers.
12