20
CAUTION: All connections and switching must be done with the amplifier’s
master power switch positioned to “off”.
Select the Power Mode Selection
Refer to the Power Mode Selection area under installation considerations to
determine which setting to use to turn the amplifier on. Once you have
determined which mode you will be using set the switches as outlined in the
following chart:
Switch Settings
Active Light
Selection
Mode
Constant
Will light up when the
amplifier is “On/Active”
and will go off when it
is “off”.
Power Mode Selection = Set to
“Constant”.
Master Power Button = Push to “In”
position to turn amplifier “On”, out
position is “Off”.
Trigger
Will light up only when
the amplifier receives an
audio signal to the
main inputs indicating
the amplifier is
“ON”/active. Will turn
off three minutes after
the signal has stopped.
Power Mode Selection = Set to
“Trigger”.
Master Power Button = Leave in the
“On” position (Button in).
Audio
Sense
Will light up only when
the amplifier receives a
voltage indicating the
amplifier is “On/Active”.
Will turn off once the
voltage has stopped.
Power Mode Selection = Set to “Audio
Sense”.
Master Power Button = Leave in the
“On” position (Button in).
INSTALLATION
19
Placement
DO:
• Place the amplifier with the feet resting on a solid flat level surface.
• Place the amplifier in a well-vented area to provide proper cooling. In
areas that lack proper ventilation, such as tight cabinets or racks, it may
be necessary to install small fans to create air movement.
DON’T:
• Don’t block the ventilation holes on the top or bottom of the amplifier.
Never place it on carpeting or similar material.
• Don’t place the amplifier in any other position other than horizontal
with the feet down. Never place on its side or resting on the back
where the terminals are located.
• Don’t the amplifier near heat sources, or in an area that it would be
exposed to moisture.
YOU SHOULD KNOW
• The power supply is very large and therefore may cause a hum to be
heard in some components if they are placed very close to the amplifier.
INSTALLATION CONSIDERATIONS
