
BEF275-1
Operating Manual
SAFETY
Only trained operatives should be allowed to work the BEF275.
All operatives should wear ear defenders, goggles and an effective dust mask.
Note; It is possible that the noise level produced by the BEF275 could exceed 90dbA. Personal
noise protection must be worn.
To control dust, it is recommended that an SPE dust control unit is used in conjunction with the
machine.
Never leave the BEF275 unattended while in use. Always stop the engine and set the height
adjustment fully up before leaving the machine.
Always ensure that the engine switch is in the off position and disconnect the spark plug cap
before attempting to service the machine. Never remove the side plate or belt guard until the
cutter drum has come to a complete standstill. Never tip the machine backwards until the cutters
have come to rest.
Never operate a petrol engine BEF275 inside or in a poorly ventilated area. Carbon monoxide gas
is emitted.
Never refill the petrol tank whilst inside a building.
Always stop the engine before refuelling.
Never refill the petrol tank when the engine is hot.
Never release the machine from operators control during use. The cutting action of the
drum will propel the machine forward at high speed. If the operator has any problem whilst
operating the machine, turn the red stop button on the engine or tip backwards.
Noise and vibration will occur at various levels dependant on the attachments and work being
completed. SPE have assessments conducted under test conditions detailed in the operating
manual. (See page 17). However it is recommended that additional tests are taken on site to
provide the operator with accurate information on using the equipment within the guidelines
laid down by the health and safety executive.
6