Spartus 130XT, Руководство пользователя

Страница: 14 / 20

USER’S MANUAL
EN
12
5.2.5 Adjusting the distance between face and helmet
If the distance between the welder’s face and the helmet body is too small, change the distance
settings. Headgear has 3 levels of distance regulation. To set right distance from the face use
the mechanizm
20 .
Release pin and set the right distance level. Remember that it has to be
simetrical regulated on both sides of headgear.
5.2.6 Incline angle adjustment
An inappropriate angle of inclination may cause discomfort during operation or cause the visor
to move over the head of the operator when tilting the head.
Incline angle adjustment can be made by using angle adjusting shim
17
in to both sides.
5.2.7 Automatic welding filter lifting system
SPARTUS® Pro 930XT helmet has been
designed and equipped with a special
mechanism for raising and lowering the
welding filter. When lifted, the helmet’s
center of gravity is lower and coincides with
the head’s center of gravity. This reduces the
welder’s neck tiredness and significantly
increases his comfort of work. The field of
view also increases – 165x72mm, and the
welder’s eyes are protected by a protective
glass.
Warning! The lever should be adjusted simultaneously with two hands – up (when lifting) and down (when
lowering).
5.2.8 Turning on the grind mode
SPARTUS ® helmets have a grinding function. To enable the grinding function, set the switch
1
into GRIND position. The degree of protection for the grinding function is DIN 4.
In SPARTUS® Pro 930XT model it is also possible to lift the automatic welding filter with special
levers. We get a larger field of view – 165x72mm, while maintaining eye protection through an
external protective glass.
6. MAINTENANCE
Maintenance and repair work may be performed only by qualified personnel with the appropriate
permissions. Regular maintenance provides adequate service life and trouble-free operation of the
welding helmet.
Daily: (before use/installation):
• Perform visual inspection of the helmet, knobs, welding filter.
• Check for proper operation of welding filter using TEST button
5
.
• Visually inspect the technical condition of the outer guard and the inner guard. Worn or
damaged covers should be replaced by a new one.
• Visually inspect the technical condition of the optical sensors.