The time required for the query to succeed depends on the current location, the GPS
antenna, and the module itself.
The maximum timeout query is set to 7 minutes. If the query is not successful after 7
minutes, the camera will be shut down.
b. The Schedule Event 01 will kick in and it will also enable the GPS query function. If the
query is successful, the Status Report (including the queried GPS coordinate information)
will be sent to the server.
The maximum timeout period of the query is 3 minutes. If the query is not successful for 3
minutes, the Status Report will still be sent to the server.
2. The camera is stolen.
2.1. The antenna is unplugged, SD card is inserted, and the Send Mode is set to Off.
2.1.1. Setup mode
GPS queries will not be turned on.
2.1.2. On mode
Prerequisite:
Camera Locator
is set to
Yes
and successfully updated to the camera.
a.
Any movement of the camera itself will trigger the G-sensor, so that the camera
wakes up and starts the GPS query function. If the query is successful, the Status
Report (including the queried GPS coordinate information) will be sent to the server.
The time required for the query to succeed depends on the current location, the
GPS antenna, and the module itself.
The maximum timeout query is set to 7 minutes. If the query is not successful after
7 minutes, the camera will be shut down.
b.
Set the Schedule Event type to Status Report.
When Schedule Event is set to work, the GPS query function will also be enabled. If
the query is successful, the Status Report (including the queried GPS coordinate
information) will be sent to the server.
The maximum timeout period of the query is 3 minutes. If the query is not
successful for 3 minutes, the Status Report will still be sent to the server.
Note: Since the antenna is unplugged, the Status Report cannot be guaranteed to be successful
although the test results were successful.
2.1.3. Off mode
Prerequisites:
Camera Locator
is set to
Yes
,
Camera Tracker
is set to
Yes
, and the
settings are successfully updated.
a.
Any movement of the camera itself will trigger the G-sensor, so that the camera
wakes up and starts the GPS query function. If the query is successful, the Status
Report (including the queried GPS coordinate information) will be sent to the server.
