4.5 INCH HYDRAULIC CHIPPER
1
2
WARNING
If any bolts or nuts are dropped in the machine, be sure
to remove them before starting the machine.
2.1 DISCHARGE ASSEMBLY
1. Move the chipper deflector weldment located inside
the chipper housing to the down position (Figure 2.1).
2.2 CHUTE ASSEMBLY
1. Attach the
chipper chute
to the chipper using four (4)
3/8 x 1" carriage bolts, 3/8" washers and 3/8" nuts.
Use two bolts on each side. Install with nuts on the
outside.
2. Attach the
chute extension
to the chipper chute using
three (3) 3/8 x 1" carriage bolts, 3/8" washers and 3/8"
nuts. Install with nuts on the outside.
3. Use the
lanyard
to attach the chute extension to the
middle hole on the chipper chute.
4. Attach
chute flap and flap strip
to the chipper chute
as shown below with the three (3) 5/16 x 1" carriage
bolts, 5/16" washers, and 5/16" nylock nuts.
5. Latch
the chute extension to the lock plate on the
chipper chute.
LANYARD ATTACHES HERE
CHUTE EXTENSION
LATCH
FIGURE 2.1, CHIPPER DEFLECTOR WELDMENT
2. Slide the discharge cap onto the chipper housing
(Figure 2.2).
3. Insert two (2) 3/8" x 5-1/2" bolts into the bolt holes on
the chipper housing and tighten using 3/8" washers
and 3/8" nylock nuts.
CHUTE FLAP
FLAP STRIP
CHIPPER CHUTE
LOCK PLATE
FIGURE 2.2, DISCHARGE CAP
FIGURE 2.3, CHIPPER CHUTE EXTENSION
