6
MAIN CABLE HARNESS WIRING
Connections to the vehicle wiring will be made using scotchlok connectors as
follows;
HARNESS LOCATION
Feed the 3 and 5 way harness through the flexible rubber sleeve and position
the assembly to the rear of the main alarm module.
IMPORTANT:
Do not connect wiring harnesses to the alarm until all wiring
has been connected.
ARMED INDICATOR LED
Remove the retaining nut from the LED bezel. Drill a suitable mounting hole in
the dashboard where the armed indicator may be seen from outside the
vehicle, as a visible deterrent.
Feed the two way connector through the hole and secure the LED bezel with
the retaining nut. Route the wires through a bulkhead grommet to the alarm
and push them carefully through the flexible rubber sleeve. Insert the two way
connector into the socket on the rear of the alarm.
Operation:
When the alarm is armed, the red LED will illuminate. Following the 20 second
exit delay, the LED will flash at 1 second intervals to indicate the SR90 is fully
armed. If the alarm is triggered and completes a full alarm cycle (50 seconds),
the LED will flash at half second intervals to indicate that a violation has
occurred.
ADDITIONAL
WIRE
EXISTING
WIRE
METAL
INSERT
STOP
Close the locking tab to hold the connector
together
Place the wires in position as shown
and hold carefully in place whilst
pressing firmly in the metal insert with
pliers. The metal insert automatically
strips the insulation from wires at
points of contact.
