Steps highlighted with a yellow warning triangle represent a
polarized component. Pay special attention to the component’s
markings indicating how to place it on the board.
Now that you’ve successfully soldered in the
resistor, use the same method to place and solder
the rest of the components.
Buzzer
(alarm): Insert the buzzer. The “+” on the buzzer should
align with the white “+” on the board. Flip the board over and solder
into place.
ATMega
(microcontroller): Looking at the bottom of the board,
insert the microcontroller. Make sure the notch on the chip aligns
with the white silk screen on the board. Flip the board over, then
begin to solder.
0.1μF Cap
(decoupling cap): Insert the capacitors, flip the board
over and solder.
Buzzer
14
ATmega328
13
0.1uF Cap x 2
12
CONTINUE WITH THE
BOTTOM OF THE BOARD
Page 8
[ STEPS 12 T0 14 ]
13
14
12
BOTTOM OF BOARD
Page 9
Very Important. Make sure to align the notch
here
.
