RN-52 Breakout
SparkFun Wish List
6. Status LEDs
There are two status LEDs located on the breakout board. However, if you
wish to place the board in an enclosure, these lines are broken out for
external LEDs. The LEDs are configured as open drain output, meaning
that they must be driven HIGH to activate the the LED.
LED0
LED1
Description
Flashing
Flashing
The RN52 module is discoverable.
Flashing
Off
The module is connectable.
Off
Flashing
The module is connected.
Note:
Flashing refers to the LEDs flashing alternatively. If you see the
LEDs flashing in unison, then you are in DFU mode. Please check pin 3 if
you have entered DFU mode by accident.
7. SPI
External audio codecs can be sent over the SPI lines.
8. PCM
Another option for communicating with the module is the Pulse-Code
Modulation (PCM) pins. PCM is a way to digitally represent sampled analog
signals. This is done over an I S connection. External audio codecs can be
sent over these lines as well.
Hardware Setup
Before you can configure the module, some hardware needs to be
connected. This section will cover the necessary hardware needed to work
with the RN-52.
Materials Needed
Aside from an RN-52 Breakout, you will need the following:
(2) Break Away Headers - Straight
PRT-00116
A row of headers - break to fit. 40 pins that can be cut to any size. Us…
(2) Breadboard - Translucent Self-Adhesive (Clear)
PRT-09567
**Description**: Ever wonder what goes on inside these things? Well t…
Jumper Wires Standard 7" M/M Pack of 30
PRT-11026
If you need to knock up a quick prototype there's nothing like having a …
(6) Mini Pushbutton Switch
2
Page 6 of 14
