3/3
UBERBOARDv2_DS_080612
© 2008 SparkFun electronics, inc. all rights reserved. Product features, specifications, system requirements and availability are subject to change without notice. uber board v2 is a trademark of SparkFun electronics, inc. all other
trademarks contained herein are the property of their respective owners.
UberBoard v2
2 0 0 8 . 0 6 . 1 2
or if you want to talk to the gM862 cell module (again, assuming
you have one plugged into your board), press “3” until “cell” is
shown as the current mux channel. Then press “7” to send a pulse
to the on/off pin on the gM862. Setting the baud rate in this case
isn’t so important because the gM862 auto-bauds (automatically
adjusts to whatever you send it, we typically use 38400). Lastly,
press “8” to talk to the port.
