Setup & User Guide
SPARK PUCKS
Setup Instruc�ons:
con�nued from front side
6.
Insert two M6 screws through each disk
into the inserts in the board. Tighten a few
turns with a screw driver and then rotate pucks
to desired angle.
7.
Once
pucks are in the desired loca�on
�ghten the screws.
8.
Remove the alignment tool and slide your
bindings onto the pucks and secure with snap ramp
or pin. If you’re unable to secure your bindings
loosen the screws, nudge in the toeside puck and
re�ghten the screws.
9.
Strap your boots into your bindings and check
the heel toe centering. To adjust centering replace
the alignment tool, loosen the screws, and slide
pucks toward toe or heel edge. Tighten screws and
check centering again.
10.
Repeat for other foot.
Alternate Method: Mini tool with Arc, Magneto and Burton Hitchhiker bindings.
1.
Insert an aluminum
center disk into each puck
with the degree indicators
poin�ng toward the
pointed end of the puck.
2.
Turn your binding upside
down and slide the heelside
puck into the channel.
(Heelside puck does not say
toeside edge on it).
3.
Set
the mini tool into the
binding channel.
4.
Slide the toeside puck into
the channel.
5.
Snap down the ramp or slide the pin
into your bindings to secure the pucks.
6.
Flip the binding over and set on your board where
you wish to a�ach it.
7.
Rotate center disks un�l you can see the board inserts.
Insert two screws through each disk and �ghten a few turns.
8.
Move binding around un�l it’s in just the right place, check
with boots strapped in to bindings.
9.
Tighten all the puck screws.
10.
Slide your binding off the pucks and remove
the mini tool.
11.
Repeat for other foot.
Bo�om side
of Spark Pucks, Mini
Tool, Baseplate, and Aluminum Disks
