Setup & User Guide
Setup Instruc�ons: All Bindings
More info:
Required tools:
SPARK PUCKS
Compa�bility:
Spark R&D will not be held liable for product damage due to user error. Read all instruc�ons before beginning!
Call or email us with ques�ons: +1
866 725 2085
More info at sparkrandd.com
Included parts:
2 x Toeside puck
2 x heelside puck
4 x Aluminum center disks
1 x Full Alignment Tool
1 x Mini Alignment Tool
8 x M6 x 16mm Flathead screws
Compa�ble
with all factory built splitboards with the Voile hole
pa�ern: Puck inserts spaced 3.3” (85mm) across the width of the board
and 1” (25.4mm) along the length of the board. For use with all puck
compa�ble splitboard bindings (with the excep�on of the K2 Kwicker).
Not compa�ble
with DIY splitboards (unless the Voile factory hole
pa�ern was used) or channel style boards from Voile, Burton and K2.
[3.3
inch
]
[85
mm
]
[1
inch
]
[25.4
mm
]
Voilé
Hole Pa�ern
8x
2x
2x
4x
1x
1x
Required tools:
(Found in your Spark Tool)
#3 Phillips head screwdriver
1.
Assemble your split in board mode.
If equipped with Voil
é
hooks clamp them
together.
2.
Stand on your board and decide where you
want your feet. Mark a dot where the center
of each foot will be on the board seam.
3.
Place the full alignment tool on the board. Insert a
toeside puck (marked with “toeside edge”) and a
heelside puck into the alignment tool.
4.
Locate the tool over the center mark of one of
your feet.
5.
Drop an aluminum center disk into each of the pucks.
Degree indicator marks should point toward the center
line of the board. Rotate so you can see the board
inserts through the slot in the disk.
