Spandau pumpen PXA 02 Series, Оригинальная инструкция по установке

Страница: 17 / 35

6. Transport, delivery and storage page 17
EN
6. Transport, delivery
and storage
SKF Lubrication Systems Germany AG products
are packaged as is usual in the trade in
accordance with the regulations of the recipient
country and in accordance with DIN ISO 9001.
Our products must be transported with care.
Products must be protected against mechanical
influences such as impacts. Transport
packaging must be labelled with the
information 'Do not drop!'.
The product must not be tipped up
or dropped.
There are no restrictions relating to land, air, or
sea transportation.
Following receipt of the shipment, the product
or products must be checked for damage and
the shipping documents should be used to
make sure that the delivery is complete. Keep
the packaging material until you are sure that
there are no delivery discrepancies that need to
be clarified.
The following conditions apply to the storage of
SKF Lubrication Systems Germany AG
products:
6.1 Pumps
•
The pump must be transported only by
means of the transport eyes (if provided).
•
For storage ensure dry, dust-free and low-
vibration (veff  0.2 mm/s) environment.
We recommend to store the unit in vertical
position.
•
If stored for longer periods, the usability
period of the grease in the bearings is
reduced.
•
If the unit is stored for more than 12
months, the condition of the grease must
be checked before the unit is taken into
operation. Also, the isolation resistance
between motor winding and housing must
be measured. If the resistance is  1 k per
Volt rated voltage, the motor winding must
be dried.
6.2 Electronic and electrical devices
•
Ambient conditions: Dry, dust-free
environment; storage in well-ventilated,
dry area
•
Storage time: 24 months max.
•
Permitted air humidity: < 65%
•
Warehouse temperature: 10 - 40°C
•
Light: Direct sunlight/UV radiation must be
avoided; nearby sources of heat must be
screened
6.3 General information
•
Ensure that no dust gets into stored
products by wrapping them in plastic film
•
Store products on racks or pallets to
protect them from rising damp
•
Before placing products into storage,
protect uncoated metal surfaces - and
drive parts and mount surfaces in
particular - from corrosion using long-
term corrosion protection
•
At 6-monthly intervals: Check products for
corrosion. If signs of corrosion are found,
improve the corrosion protection
measures.
•
Drives must be protected against
mechanical damage