Page 23
Maintenance
(Continued)
Replacing J4 Type Halogen Light Bulb:
When the range hood uses J4 type halogen light bulb: 20W 12V.
•
Make sure the range hood is unplugged or turn OFF breaker and the
•
lights are cool to touch.
Place a small flat-head screwdriver between light housing and lens cover, carefully and gently pry up the lens cover.
•
Remove the old halogen light bulb by pulling in the direction of wavy arrow. Do not touch the new light bulb with
•
bare hands.
Reverse the steps to install a new halogen light bulb. Turn ON breaker and range hood to test for operation.
•
Replacing E12 Type light bulb:
When the range hood usesE12 type light bulb: 20W 12V or 40W 120/220V.
•
(please contact your local reseller for replacement)
Make sure the range hood is unplugged or turn OFF breaker.
•
Place a flat-head screwdriver between light cover and hood casing, gently pry to remove light cover.
1.
Gently unscrew defective bulb straight out and discard.
2.
Wear a cotton glove or use a cloth to handle the replacement bulb (DO NOT handle with bare fingers as this may
3.
shorten the life of the bulb). Tighten gently but securely into light socket. NOTE: DO NOT tighten too hard as bulb
may break off.
Replace light cover.
4.
Turn ON breaker and range hood to test for operation.
•
Replacing MR16 / GU10 Type Halogen Light Bulb:
When the range hood uses MR16 or GU10 type halogen bulb (please refer to
•
the actual specification of the hood purchased):
USA/Canada:
35W Type MR16 12V / Type GU10 120V
Europe and other Countries:
35W Type MR16 12V / Type GU10 220V
Make sure the range hood is unplugged or turn OFF breaker.
•
Make sure the lights are cool to touch, carefully align the arrow on the inner
•
ring with the arrow on the outer ring where it says OPEN. The inner ring will
loosen and the light bulb will be available for removal. Install a new halogen
light bulb and reverse the steps.
Turn ON breaker and range hood to test for operation.
•
Align arrows on both rings
WARNING
Hazard of Burns!
Light bulb become extremely hot when turned on.
DO NOT touch bulb until switched off and cooled.
Touching hot bulbs could cause serious burns.
Light
Cover
Hood
Casing
Flat-head Screwdriver
Light
Bulb
Light
Cover
Light Housing
Flat-head
Screwdriver
Lens Cover
Lens Cover
Halogen Bulb
Lens Cover
