USER MANUAL for the SG-0007B SYSTEM
1
This product is meant to be used for electronic control of functions for spa baths. Please read all of the
instructions carefully before enjoying the spa. WARNING:
Operating the system without water will cause severe
damage. Contains electronic components, shock hazard. Does not contain user serviceable parts. Do not try to repair
the control unit. Contact your dealer or service center for help. Follow all user instructions.
I. Installation
1)
Open the door / cover according to the instructions and connect the power supply correctly.
Warning
A.
Installation is only to be made by qualified persons.
B.
Read the instructions carefully before beginning the installation.
C.
We are not responsible if the product does not work or is damaged when the
instructions are not followed during installation.
D.
Ensure that the system is not damaged during transportation when it is unpacked.
Note!
A.
1 x 16A (Read “Interlocked system between the heater and pumps”), 2 x 16A or 3 x 16 should be connected
to the control system. Do not connect the power before the installation is complete.
B.
Install a maintenance switch close to the control system for use during maintenance work.
C.
An earth switch must be installed. Check that the earth switch works when the power is connected.
(Figure 1)
WIRING DIAGRAM 3-phase, 2-phase, 1-phase
SG0007B Sketch Of Linking Wires For The System
