UNB_PDU_INSTR_01.19
Page 4 of 4
1
2
3
1 – Lay drawer side (J) on a flat surface, insert the base (M) into the groove then hold the back panel (I) in place. 2 – Place the other drawer side (K) over the base and fasten the back panel (M).
3 – Turn the drawer around and add the drawer front (L) . (Repeat on all drawers).
12
PRELIMINARY DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
QUOTATION PURPOSES ONLY
ISSUED DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
ISSUED TO: SUPPLIER
13
1 - Pull the sliding part of the lower drawer runners out and sit
the drawer on top. Whilst holding the runners in place, slide the
drawer back until the drawer clicks into place.
2 - Use the locking button to secure the drawer. Repeat for all
drawers. To remove a drawer, reverse the operation.
1
2
x2
x2
Drawer base
Drawer base
Drawer side
Drawer back
Drawer side
Drawer back
Drawer front
Pull the sliding part of the lower
drawers out first and hold in place.
Drawer shown
from underneath.
Locking button
Turn to
adjust height
