www.spacemanusa.com
Phone: (720) 328-1020
Email: [email protected]
8. Rotate draw valve until the flat part at the top is
perpendicular to the clear face of the dispensing
door (use towel if necessary)
9. Remove ice buster
10. Remove draw valve, twisting it while removing
11. Remove draw valve O-rings (2) using O-ring tool
12. Unscrew and remove prime plug from dispensing
door
13. Use a towel to remove drive shaft at the back of
the cylinder
14. Separate drive shaft gasket from drive shaft
15. Remove front drip tray and internal drip tray
1. Verify the power switch is turned to OFF
2.
Remove the torque arm, first pulling up out of the
torque assembly and then down out of the flat sensor
arm;
DO NOT LIFT UP ON CURVED SENSOR ARM
3. Remove dispensing door hand-screws (4)
4. Remove dispensing door assembly, torque assembly
(including torque guide), and beater assembly
5. Remove torque assembly O-ring using O-ring tool;
remove torque guide
6. Remove scraper blades (2) from beater assembly;
separate scraper blade clips (2) from scraper blades
7. Remove dispensing door gasket using O-ring tool
1
7
10
3
9
11
4
12
6
2
Cleaning: 2. Disassemble
9
14
15
NOTE: Prepare dishwashing area prior to disassembly, and
use a bucket to temporarily store removed parts.
CAUTION: Always separate O-rings and gaskets from metal
parts to prevent damage while washing.
8
14
5
13
15
