
PART
QTY
1. Base . . . . . . . . . . . . . . . . . . . . . . . 1
2. Casters . . . . . . . . . . . . . . . . . . . . . 5
3. Pneumatic Cylinder . . . . . . . . . . . . 1
4. Seat Plate . . . . . . . . . . . . . . . . . . . 1
5. Seat Cushion . . . . . . . . . . . . . . . . . 1
6. Back Assembly . . . . . . . . . . . . . . . 1
7. Short Screws . . . . . . . . . . . . . . . . . 4
8. Flat Washers . . . . . . . . . . . . . . . . . 6
9. Long Screws . . . . . . . . . . . . . . . . . 6
10. Allen Screws . . . . . . . . . . . . . . . . 3
11. Arms Left (11L) Right (11R). . . . . 2
12. Back Support (Pre-Installed) . . . . 1
13. Allen Wrench . . . . . . . . . . . . . 1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
STEP 2
Attach Arms (11L & 11R) to Seat Cushion (5) using three Long Screws (9) and three Flat Washers (8) for each arm.
TIGHTEN ALL SCREWS USING PHILLIPS SCREWDRIVER. (not provided).
STEP 3
Attach Seat Plate (4) to Seat Cushion (5) with arrow pointing towards the front of the chair, using four
Short Screws (7).
FULLY TIGHTEN ALL SCREWS USING PHILLIPS SCREWDRIVER (not provided).
STEP 4
Attach Back Support (12) to Seat Plate (4) using three Allen Screws (10).
FULLY TIGHTEN SCREWS
USING ALLEN WRENCH (13)
STEP 5
Insert Pnuematic Cylinder (3) into Base (1) and place the assembled seat on top of Pneumatic Cylinder (3)
and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
1587C EXECUTIVE CHAIR
ASSEMBLY INSTRUCTIONS
© Office Star Products July 2007
STEP 1
STEP 2
STEP 3
STEP 4
X5
X4
2
11R
11L
13
1
1
3
X3
12
4
9
8
4
5
6
X3
X3
X3
X3
5
7
9
8
STEP 5
10
Phillips Screwdriver also needed for
assembly (not provided)