Space-Ray LRDL15, Инструкции по сборке, установке и эксплуатации

Страница: 3 / 51

Form #44201117
-2- Dec 2021
1.0) SAFETY
This heater is a self-contained infrared radiant tube heater. Safety information required during installation and
operation of this heater is provided in this manual and the labels on the product. The installation, service and
maintenance of this heater must be performed by a contractor qualified in the installation and service of gas
fired heating equipment.
All personnel in contact with the heater must read and understand all safety information, instructions and labels
before operation. The following symbols will be used in this manual to indicate important safety information.
Warning instructions must be followed to prevent or avoid hazards which
may cause serious injury, property damage or death.
Caution instructions must be followed to prevent incorrect operation or
installation of the heater which may cause minor injury or property
damage.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure
that they do not play with the appliance.
2.0) INSTALLER RESPONSIBILITY
The installer is responsible for the following:
•
The heater and venting, as well as electrical and gas supplies must be installed in accordance with these
installation instructions and any applicable codes and regulations.
•
Every heater shall be located with respect to building construction and other equipment so as to permit
access to the heater.
•
Each installer must follow the clearances to combustible materials for the heaters.
•
Install the heater so that the supports and hangers are correctly spaced in accordance with these
instructions. The heater must be supported by materials having a working load limit of at least 52kg.
•
Supply the owner with a copy of these Installation and Operation Instructions.
•
Never use the heater as a support for a ladder or other access equipment. Do not hang anything from the
heater.
•
Supply all installation materials necessary that are not included with the heater.
•
Check the nameplate to make sure that the burner is correct for the gas type in the building.
•
Install the heater in accordance with best building practices.
3.0) GENERAL INFORMATION
This heater is a self-contained infrared radiant tube heater designed for use where flammable gases or vapors
are not generally present.
Installation of this heater must be in accordance with all applicable codes shown in the instructions and/or the
local codes and authorities having jurisdiction. In the UK all equipment must be installed and maintained in
accordance with the relevant provisions of the Gas Safety (Installations and Use) Regulations 1998 for gas fired
products. Installation practices must take into account the Health and Safety at Works Act 1974 or relevant
codes of practice. In addition the installation must be carried out in accordance with the current IEE wiring
regulations (BS 7671-latest revision), BS 6896-latest revision (Industrial & Commercial) and any other relevant
British Standards and Codes of Practice by a qualified installer. All external wiring MUST comply with the current
IEE wiring regulations.
Clearances to combustibles as outlined in the manual should always be observed. In areas used for storage of
combustible materials where they may be stacked below the heater, the installer must post signs that will
“spec ify the maximum permissible stacking height to maintain the required clearances from the heater to
combustibles.”
Every heater shall be located with respect to building construction and other equipment so as to permit access
to the control housing. Each installer shall use skillful and reliable installation practices when locating the
heaters and must give consideration to service accessibility.