6
1-2. Adjust the Brightness of CMOS
In the above camera scanning mode, adjust the LED light built in the head of the
gooseneck to realize the operation in different circumstances.
Increase the backlight level by each press on the "" button until brightest and
backlight level displays on the top left corner of the screen.
Decrease the backlight level by each press on the "BRIGHT-" button until turn-off.
(10 stands for the brightest, 0 for the darkest and the LED goes out when 0.)
1-3. Rotate the Images
In camera mode, press up/down button to adjust the angle on the screen to get a suitable
image displayed.
Image angle can be rotated from 0° to 180° with up/down button, which will greatly
facilitate the detection.
1-4. lmage
In camera mode, each press the "SNAP" button will save an image, (Enter into
"Date/Time" in the System setup /time menu, the current time and date will display on the
saved image. Enter into "Close Date/Time" in the same menu, no current time and date
will display on the saved image)
1-5. Video
Under video mode, hold the "RECORD" button for three seconds to enter into the video
mode with a video symbol displaying and flickering on the top left side of the screen.
Meanwhile, a dynamic memory capacity will be displayed at the left bottom indicating the
current available memory capacity. When the capacity was used up, a dialog box will
appear to advice of insufficient memory capacity. Preserve the current video file by
pressing "RECORD" button. The video can be played in "System setup \Explorer\video
player" menu.
1-6. System Setup
Press "OK" button under camera mode to pop up a "MENU" dialog box.
Select "Yes" with the left right butt on, and then press "OK" button to enter into Main
Interface "System Setup".
2. System Set
2-1. Under the camera scanning mode, press "OK" button, and the following dialog box
pops up.
Содержание SP70935
Страница 4: ...4...
