1.- BEFORE IGNITION
1.1 Fill the fuel tank with gasoline and oil. 4 cycle engines do not require an oil or
gasoline mixture.
1.2 Adjust the hose and nozzle connections perfectly. Make sure there are no seals
missing.
1.3 Verify that the filter and the tank drain plug are secured before filling it.
1.4 When preparing the mix, add water to half the tank; add the chemical, and fill with
water.
2.- IGNITION
2.1
Lift the choke lever and pump the primer located next to the fuel tank a few times,
until the fuel return transparent hose is filled up.
2.2 move the acceleration lever upwards approximately one third.
2.3 Pull the starter cord until the motor turns on.
2.4 Open the choke slowly depending on the motor temperature.
2.5 Once turned on, move the choke slowly to its limit, while you observe the motor
operation.
2.6 Leave the motor at low speed for some minuts before beginning the spray
work.
2.7 If the motor does not turn on easily, take off the spark plug and do the following:
a) Ensure the spark plug produces sparks when starting.
b) When there is too much gasoline flow, the spark plug dampens. Dry it.
NOTE: Always consult the instructions manual.
