Hose clamps are not completely tight.
Please tighten hose clamps prior to using.
Hose clamps are left loose to extend life
of
seals
and fittings.
Lubricate all moveable rubber pieces with
Silicone Grease (o-rings, seals, spindle in
gun, piston cup (when applicable). Keep
breather hole in lid clear of debris. Lubricating
the seals and keeping the breather hole open
allows air into the tank. Without airflow, the
tank may collapse and crack due to a vacuum
created by the pump.
1. Attach spray wand to spray gun and
tighten firmly.
2. Take pump handl
e and insert into the
tube
on the pump lever. You will notice
holes drilled through both sides of
the pump handle and lever. Align
these holes, take the "R"pin provided
and place through the holes. This
affixes the handle in place and is ready
for use. For storage, reverse the above
process, and then place "R"pin through
the pump lever to keep from losing
the "R"pin.
3. Instructions for installing shoulder strap
plastic buckle:
First, put the sprayer on a hard flat
surface, take the white plastic buckle
and while holding the sprayer up
slightly, place the buckle under the
metal frame. Slowly push down forcing
the frame into the buckle. Repeat the
same procedure for the other side.
5. Set up
Make sure to insert the locking pin for the
pump handle in its (only) CORRECT
POSITION.
The pin limits the pump stroke for
optimum performance.
Observe Fig. 1
exactly. (Fig. 2 and 3 spell
trouble)
For best results and to maintain a good
seal, re-grease piston
cup
periodically
with
Silicone Grease. Do not use any
petrolium based lubricants or WD-40,
they will damage the o-rings and seals of
your sprayers. Only Silicone Grease is
recommended for lubrication of SP sprayers.
HOW TO ASSEMBLE
Fig. 1
Fig. 2
Fig. 3
US-6
Содержание EcoScape
Страница 2: ......
