SP Scientific VIRTIS ADVANTAGE PRO, Руководство оператора

Страница: 16 / 78

Getting Started VirTis AdVantage Pro
6 Rev 002, 01/14
© SP Scientific 2014
Lifting the AdVantage Pro Freeze Dryer
If no damage was discovered following the initial inspection of the AdVantage Pro,
SP Scientific recommends using a moving assistance device (
e.g., lift trolley) to safely
lift the unit into place. Ensure that at least two (2) individuals are available to safely lift
the unit on and off the moving assistance device. The AdVantage Pro should be lifted
at
the metal frame near the unit’s four (4) feet, not at the front panel.
WARNING! THE ADVANTAGE PRO WEIGHS APPROXIMATELY 309 LBS
(140 KG). ALWAYS PRACTICE TEAM LIFTING WHEN MOVING HEAVY
EQUIPMENT.
AdVantage Pro Setup
Position your AdVantage Pro unit so it rests firmly and level on the desired location.
Allow sufficient space so the unit may be easily connected and ensure that the area
around the unit provides for adequate air circulation. The back of AdVantage Pro
should be at least 4 inches (10.2 cm) away from the wall.
Note: For efficient operation, SP Scientific recommends an operating range of 15 - 25 °C
(59 - 77 °F).
Service Connections
Ensure that the outlet you intend to use meets the service requirements listed on the
AdVantage Pro
’s serial tag, which is located on the rear panel of your unit. Plug your
unit into an appropriate outlet and switch on the On / Off Switch located at the lower
left corner of the right side panel (when facing the unit). The
Intellitronics™
touch-screen display will illuminate.
Note: The AdVantage Pro is configured with an IEC60320 C20 inlet on the back of the unit.
This inlet allows country specific power leads to be supplied.
Do Not Lift at Front Panel
Lift Here Lift Here