Hardware Installation
SY-7VCA2
43
2-3.4 CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory by
momentarily shorting pins 2-3 on jumper JP5, for a few seconds. Then
restore JP5 to the initial 1-2 jumper setting in order to recover and retain
the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Clear CMOS Data
Retain CMOS Data
JP5 Setting
Short pin 2-3 for
at least 5 seconds
to
clear the CMOS
Short pin 1-2
to retain new
settings
Note:
You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
2-3.5 Power On
You have now completed the hardware installation of your Motherboard
successfully.
1.
Turn the power on
2.
To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note:
If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
1 2 3
1 2 3
Содержание SY-7VCA2
Страница 99: ...95 ...
