SOYO SY-6ICA, Быстрый старт

Страница: 12 / 26

SY-6ICA Quick Start Guide
12
Hardware Installation
Step 9.
CPU Safe Mode (JP7)
If the user overclocks the system there is always the risk that the system will not boot up
properly. In that case closing JP7 will force system to use the actual CPU multiplier to boot
up. The boot-up sequence in that case will be as follows:
Ø
-The system will start up with the lowest multiplier available.
Ø
-The BIOS will now read the CPU-ID code and set the multiplier in accordance with it.
Ø -The system will boot up normally with the actual (non-overclock) CPU frequency.
CPU Safe Mode Normal Force actual CPU Frequency
JP7 Setting Open JP7 Close JP7
Note: After properly booting up, set JP7 back to open again.
Step 10.
CMOS Clear (JP5)
After you have turned off your computer, clear the CMOS memory by momentarily shorting
pins 2-3 on jumper JP5, for a few seconds. Then restore JP5 to the initial 1-2 jumper setting
in order to recover and retain the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS Clearing
Clear CMOS Data Retain CMOS Data
JP5 Setting
Short pin 2-3 for
at least 5 seconds to
clear the CMOS
Short pin 1-2 to
retain new
settings
Note: You must unplug the ATX power cable from the ATX power connector when
performing the CMOS Clear operation.
1 2 3 1 2 3
1 2
1 2