Hardware Setup
11
SPEAKER – Speaker Connector
Attach the system speaker to connector SPK.
RESET – Hardware Reset Control
Attach the Reset switch to RESET. Closing the Reset switch restarts the
system.
IDE1/IDE2 – On-board Primary/Secondary IDE HDD
Connectors
Attach on-board hard disk drives to these connectors.
COM1/COM2 Connectors
Connect COM1/COM2 devices to these connectors.
HDD LED – IDE HDD LED Connectors
Attach on-board IDE device LEDs to this connector. The LED lights
when an IDE device is active.
FDC Connector
Attach floppy cable to this connector.
PRT – Parallel Port Connector
Attach parallel port cable to this connector.
USB (J3) – (Universal Serial Bus) Connector
Attach USB cable to these connectors for external USB device. Please
ask your dealer for the cable.
PW/SW – ATX Power Supply On/Off Switch Connector
(Momentary Type)
Attach a two-pin switch to this connector for turning the ATX power
supply on/off. DonÕt forget to remove all jumper caps on JP12 to enable
the ATX power supply function.