22
23
STEP 3 - CHECK THE CHAIN BRAKE
This machine is equipped with a chain brake that will
immediately disable the chain upon the occurrence of kickback
during cutting. The brake is automatically operated by inertia
forces, which act on the weight fitted inside the front guard.
This brake can also be operated manually with the front guard
pushed forward to the guide bar. To disengage the chain brake,
pull it back until it touches the front handle.
b
a
a= brake disengaged b= brake engaged
IMPORTANT!
Be sure to confirm the correct brake operation
every time you use the machine, and periodically during use.
How to confirm if the chain brake is functioning
correctly
1. Turn off the engine and leave until it is cold.
2. With the chainsaw on a flat surface and the chain tensioned
correctly, engage the chain brake by pushing it forward until
an audible click is heard. Then, wearing protective gloves,
attempt to move the chain by hand in the direction of normal
rotation; if this is not possible, the chain brake has been
engaged. If the brake is engaged when the chain is rotating
at high speed for extended periods of time, this can cause
damage to the clutch or for it to fail completely. When the
brake is activated whilst cutting, immediately release it,
having first released the throttle lever, and set the chainsaw
to ‘O’. Call the service centre for more help.
STEP 4 - STOP THE ENGINE
1. Release the throttle lever to allow the engine to idle for a few
seconds.
2. Set the switch to the ‘STOP’ position.
switc
h
IMPORTANT!
Do not put the chainsaw on the ground while it is
still running. For additional safety, switch the chainsaw off when
not in use or between cuts. In the event that the ignition switch
will not stop the saw, pull the choke control out and engage the
chain brake to stop the engine. Call the service centre.
NOTE:
When you have finished using the saw, always relieve the
tank pressure by loosening, then retightening, both tank caps.
Allow the engine to cool before storing.
STEP 5 - SAWING
WARNING!
Before proceeding with your job, read
the ‘Safety instructions’ section. It is recommended
to first practice sawing easy logs. This also helps
you get accustomed to your unit. Always follow the
safety regulations. The chainsaw must only be used
for cutting wood. It is forbidden to cut other types of
material. Vibrations and kickback will vary with materials
other than wood, and the requirements of the safety
regulations will not be met. DO NOT use the chainsaw as
a lever for lifting, moving or splitting objects.
