23
Figure 12
Adjusting the spray
The nozzle on spray lance is adjustable to allow you to adjust
the spray from a tight beam of water to a wide spray.
To adjust the nozzle, proceed as follows:
1. Hold the shaft of the lance in one hand.
2. Twist the nozzle with the other hand. See figure 12.
3. The tight beam should be used to clean small areas where
a small spray is required.
4. The wide beam should be used for cleaning large areas.
Total stop system
The pressure washer is fitted with a total stop system to
protect the motor when in use.
When the trigger is released the motor will stop.
When the trigger is squeezed the motor will start up again.
Caution!
Some painted or treated surfaces may be susceptible
to damage from the high pressure jet washer.
When cleaning vehicles for example, always check with the
manufacturer whether surfaces are suitable for pressure
cleaning or whether any restrictions apply.
