Sovereign 484341, Инструкция по эксплуатации

Страница: 14 / 16

26 27
1. Tip the machine slightly towards the oil filler pipe and reach
under the deck.
2. Hold the blade and unscrew the blade bolt counterclockwise
using a spanner wrench. Remove the washer and the blade.
3. Inspect the blade adaptor for any signs of damage.
4. Fit a new blade, locate the blade on the two studs on the
blade flange and then replace the washer and bolts.
5. Check the washer is still slightly domed to keep the pressure
on the bolt to stop it unwinding, keeping the blade firmly
secure. Then replace the washer (right way around!) and
bolts.
6. Make sure the blade is correctly located, and then firmly
tighten the bolt. Do not over tighten. The up turn of the blade
must project into the motor compartment.
NOTE! If you are unsure about performing this operation, call
our helpline or go to an authorised dealer to change the blade
for you.
List of consumable parts:
LD K7TC Spark plug 916204 Blade bolt
916901 Collection grass bag 466018 Fixing knob
1181206 Blade
Parts can be ordered via www.gardenservicecentre.co.uk
TROUBLESHOOTING
WARNING!
- Always switch off the engine and pull the ignition cable
before starting any inspection or adjustment work.
- If after making an adjustment or repair to the engine
you let it run for a few minutes, remember that the
exhaust and other parts will get hot.
The following table provides solutions to common problems
encountered with the lawnmower:
Fault Possible cause Solution
Loud while
running, machine
vibrates heavily
- Screws are loose
- Blade fasteners are
loose
- Blade is unbalanced
- Check screws
- Check blade
fasteners
- Replace blade
Engine does not
start
- start/stop bar not
pressed
- Primer bulb is
empty
- Spark plug is
defective
- Fuel tank is empty
- Engine may be
flooded
- Press start/
stop bar
- Press primer
bulb 3~5 times
- Replace spark
plug
- Refill with fuel
- Remove plug
and dry, see
page 24
Engine runs
unsteadily
- Air filter is soiled
- Spark plug is soiled
- Clean the air
filter
- Clean the
spark plug
Uneven mowing
results
- Blade is blunt
- Cutting height is too
low
- Sharpen the
blade
- Set correct
height