7
2. Once locking pin is removed, lift or lower A-frame to
desired height. Replace locking pin.
3. Repeat above steps on other A-frame.
CAUTION
It may be necessary to replace
locking pin and readjust lifting
handle location in order to properly
lift or lower A-frame to desired height
comfortably. Failure to adjust lifting
handle to a comfortable location for
lifting may result in injury.
CAUTION
Be certain to check that lift is level
after adjusting A-frame heights before
attempting to add a load.
Gantry Span Adjustment
5m and 15 ft GH2T Gantry beams have two inner span
adjustments on each end of the beam. 3m, 4m, 10 ft
and 12 ft Gantry beams have one inner span
adjustment. Span adjustments are by increments of
13" (33 cm). 8 ft Gantry beams have no span
adjustments.
To make span adjustments during assembly, simply
place the outermost bolt on the A-Frame in the second
or third inside bolt hole on the beam. It is not neces-
sary to adjust the span symmetrically on either end of
the beam.
Moving Gantry Lift
CAUTION
It is not recommended to move
Gantry lift with a load. When
moving Gantry lift with a load be sure
to secure trolley in center of cross
beam and lower load as close to the
ground as possible prior to moving.
Move lift by pushing the Gantry, not
the load. Use caution to avoid the
load swinging, possibly hitting the
support structure.
CAUTION
Never move assembled Gantry lift
with or without a load with a forklift or
other lifting mechanism.
1. Adjust A-frame heights to lowest possible position
prior to moving.
2. Unlock all casters on both A-frames.
3. Gantry should be moved with at least two people,
one on each end. Move by pushing or pulling on the
Gantry, not the load.
