7
8
SET UP AND OPERATION
SET UP AND OPERATION
MAINTENANCE
SPECIFICATIONS
• May be used with a 1-1/4” to 3-1/2” Outside Diameter Axle
• When lifting loads over 3,000lbs utilization of the
ProJax
TM
Reel
Stand
Axle model PJA-01/PJA-02
• Model# MPJ-01/MPJ-02
• Stock # 58-13-32-01 (Single) / 58-52-64-01(Pair)
• Height – 44 Inches
• Width – 16 Inches
• Depth – 41 Inches
• Weight – 90 lbs each or 180 lbs per set
• Capacity – 5,000 lbs each or 10,000 lbs per set
• Patent Number – US 9073737
• Drill Recommendations: 18 V cordless drill with 1,000 lbs
torque or higher for reels 3,000 - 10,000 lbs.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
5. Place axle into spool (Fig 3).
6. Raise the carriage height with an 18V cordless drill (or equivalent
of 1,000 torque rated drill) until the bearings are touching the axle.
7. Lift Safety Hook into position and insert hitch pin (Fig 4).
8. Repeat steps 3-7 for the second
ProJax
TM
Reel Stand
.
9. Lift spool off the ground by attaching an 18V cordless drill with a
7/16” drive adaptor (Supplied with
ProJax
TM
Reel Stand
onto the
drive shaft and raise each side until the spool is off the ground and
can be easily rotated (Fig 2).
10. When working on uneven surfaces, a torpedo level or Speed set
is recommended to help adjust each jack stand individually.
11. Lower spool to the ground when finished.
12. NOTE: When raising and lowering carriage do not exceed the full
travel range of carriage. Doing so WILL cause internal damage to
ACME Thread and will prevent future operation.
AXLES
PROJAX
TM
RISERS
• A pair of
ProJax
TM
Risers (PJS-01) are available to extend
the capabilities of the
ProJax
TM
Reel Stands (Fig 5).
• Use of
ProJax
TM
Risers allows the
ProJax
TM
Reel
Stand to lift wire and cable reels with an OD of 104”.
1. Apply grease to the ACME threads as needed.
2. Apply light coat of lubrication to carriage roller bearings as needed.
Fig. 5
MAXIS
MAXIS
