Page 3 of 9
Copyright 2010 Southwestern Microsystems Inc. All rights reserved.
Section 1 - Installation & Connection to ADS System
The Music-In-A-
Flash™ MP3 Music System can be installed in either a vertical (wall
mounted) or horizontal (shelf mounted) position, but must be installed indoors.
Choosing a location
:
o
Position the Music-In-A-
Flash™ such that it is within 3 feet of the Input Jacks
on the ADS Primary Unit and 5 feet to a 110 volt standard wall outlet.
o
Choose a location so that the front of the player can be easily accessed should
you wish to change any of the SD cards in the future.
Mounting the player(s) to the wall:
o
If you are installing only 1 player, then use 2 - #8 screws that are supplied.
o
If you are mounting 2 players, stack players atop each other and insert a #8
screw through both mounting brackets and tighten to the wall.
You will need two #8 screws 2
”-2.5” in length to complete this task.
Connecting to Power Source:
o
Verify switch on front panel is in the “off” position (fully extended position).
o
Plug wall transformer into standard 110 volt AC wall outlet.
o
Plug round barrel power connector on supplied transformer assembly into hole,
push until it stops, on back of player labeled 6VDC - see picture below for
details.
Music-In-A-
Flash™ Rear Panel View
Instructions continue on next page
