Southbend C0300HT, Техническое руководство

Страница: 5 / 30

ADJUSTMENTS
WARNING
De-energize all power to equipment before attempting to service or replace any
component of the equipment.
CAUTION
When changing motor or servicing unit, always verify that the blower wheel rotation
is as the illustration shows. (clock-wise when looking into oven cavity)
ONLY on units manufactured before serial numbers 91 H
Blower wheel must not be located over 1/8" from rear of
oven. This is critical for proper burner combustion.
A. MOTOR: The motor is serviceable from the front of the unit through the oven cavity. Remove the rear baffle. Disconnect
the motor mount plate by removing the eight hex nuts that secure it to the oven interior back. Pull the mount plate, with motor
attached, into the oven.
B. CONTROL PANEL ASSEMBLY COMPONENTS: The control panel assembly components are easily serviceable by
removing two screws (one at the top and at the bottom) of the control panel and then sliding out the control panel assembly.
C. THERMOSTAT: After sliding out the control box assembly, the thermostat can be completely removed by removing the
capillary bulb brackets from inside of the oven, and then sliding the capillary bulb out of the oven cavity into the control area.
CAUTION
Before sliding out control box for servicing, remove base panels below oven door and
remove the wire tie from the spark ignitor electrode wire (black wire).
To return control box to original position, push in slowly while lightly pulling the spark ignitor
wire (black wire) into the oven burner control area (below oven door). Re-attach a wire tie
in a similar fashion as before it was removed. Replace base panels.
PAGE 4
BLOWER
WHEEL
ROTATION
FIGURE 1