OWNER’S MANUAL 1190820 REV 4 (10/14)
PAGE 9
OF 34
U
LTIMATE
R
ESTAURANT
R
ANGES
2. Install eye-bolt (item “F”) to a frame member on the rear of the equipment. After checking carefully behind the frame
member for adequate clearance, drill a 1/4” (6 mm) hole through the frame member.
3. Thread hex nut (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through the 1/4”
(6 mm) drilled hole and secure with a washer (item “H”) and nylon lock nut (item “I”).
4. Using the spring-loaded snap hooks, attach the restraining device to the bracket and the eye-bolt.
5. Using the cable clamp (item “D”), adjust the restraining device extended length to prevent over-bending or kinking of
the appliance connector.
Figure 4
Be sure all controls are turned off prior to disconnecting. After reconnecting, be sure all controls are turned off and all
pilots are lit.
NOTICE
Adequate means must be provided to limit the movement of the appliance without depending on the connector and
the quick-disconnect device or its associated piping to limit the appliance movement.
The restraining means should be attached to a frame member on the back of the range.
I
NSTALLATION
F
G
H
I
B
C
E
D
A
Installation of Restraint
Содержание 4365A
Страница 31: ...OWNER S MANUAL 1190820 REV 4 10 14 PAGE 31 OF 34 ULTIMATE RESTAURANT RANGES Notes ...
Страница 32: ...ULTIMATE RESTAURANT RANGES OWNER S MANUAL 1190820 REV 4 10 14 PAGE 32 OF 34 Notes ...
Страница 33: ...OWNER S MANUAL 1190820 REV 4 10 14 PAGE 33 OF 34 ULTIMATE RESTAURANT RANGES Notes ...
