N
2
-BLAST
®
Nitrogen Generator FPS-1750, FPS-3000, and FPS-6000
South-Tek Systems
Version:
7
Revision Date: 5/24/16
Page 10 of 25
4
PRODUCT INSTALLATION
4.1
UNPACKING AND PREPARATION
The N
2
-BLAST
®
Nitrogen Generator System’s cardboard carton should be
carefully opened and all parts should be inspected for damage upon receipt.
Identify and verify that all parts listed on the packing list are present and
undamaged. South-Tek Systems (STS) is not responsible for damages that have
occurred during the shipping and handling of the N
2
-BLAST
®
Nitrogen Generator.
Any visual damages should be immediately documented and reported to the
shipping company responsible. Then, contact STS at (888)526-6284 to assess the
damages only after the shipping company has been notified.
Until Installation:
o
Store the N
2
-BLAST
®
Nitrogen Generator in a dry and climate controlled
(60-80°F) room.
o
Always keep the N
2
-BLAST
®
Nitrogen Generator in an upright position or
in box as shipped.
o
Do not connect the AC power cable until this manual has been read
completely and all connections are made as stated within.
o
Keep all gas lines dry so you don’t get moisture in the generator upon
hookup.
o
Never place/stack objects on top of the N
2
-BLAST
®
Nitrogen Generator.
4.2
ELECTRICAL REQUIREMENTS
The N
2
-BLAST
®
Nitrogen Generator requires 110V / 60 Hz / 1ph connection rated
at 20 amp service. It has a built in 20A circuit breaker and a standard 3-prong US
power cord is provided for the electrical connection. The system is UL 508A ICP
approved. Electrical schematic available upon request.
4.3
MOUNTING (FOR N
2
-BLAST
®
NITROGEN GENERATOR)
It is recommended that the N
2
-BLAST
®
Nitrogen Generator
be wall mounted using
its supplied wall mounting brackets. The N
2
-BLAST
®
Nitrogen Generator should
always be installed indoors in an environment between 40° and 90° F in the
upright and level position where it will not be damaged by water or moving
equipment.
