South bend SB1025F, Руководство пользователя

Страница: 63 / 104

For Machines Mfg. Since 8/09 SB1024/SB1025/SB1026
-57-
M A I N T E N A N C E
Machine Storage
To avoid rust problems or corrosion damage,
use the following information to protect your
investment when storing the mill for any length
of time.
• DISCONNECT MILL FROM POWER!
• Lubricate the mill as directed in the
Lubrication section beginning on Page 51.
• Clean out the coolant reservoir in the base
of the mill as directed in the Cleaning
Coolant Reservoir section on Page 56.
• Thoroughly clean all unpainted, bare metal
surfaces, then coat them with a light weight
grease or rust preventative. Take care to
ensure these surfaces are completely covered
but that the grease or rust preventative is
kept off painted surfaces.
Note:
If the machine will be out of service for
only a short period of time, use way oil or a
good grade of medium-weight machine oil
(not auto engine oil) in place of the grease or
rust preventative.
• Loosen the belts to prevent them from
stretching during storage. Post a reminder
on the mill that the belts need to be re-
installed or tensioned before resuming
operations.
• Place a few moisture absorbing desiccant
packs inside the electrical and control panel
boxes.
• Cover and place the machine in a dry area
that is out of direct sunlight and away from
hazardous fumes, paint, solvents, or gas.
Fumes and sunlight can bleach or discolor
paint and plastic parts.
• At least once a month, start the mill and
run all gear-driven components for a few
minutes. This will keep the bearings,
bushings, gears, and shafts well lubricated
and protected from corrosion, especially
during the winter months.