-14-
For Machines Mfg. Since 8/09
Model SB1017
P R E P A R A T I O N
Figure 11. Wheel assembly.
Figure 12. Leveling feet.
Figure 13. Mounting bandsaw to stand.
6.
Insert the axle through the holes in the base
assembly, then slide the wheels over the axle
and secure each with a cotter pin, as shown
in
Figure 11
.
7.
Thread the leveling feet into the stand
assembly, as shown in
Figure 12
. You can
adjust these later as needed to level the
bandsaw.
8.
With the help of another person, flip the
stand assembly right-side up, then lift the
bandsaw assembly and place it onto the
stand assembly.
9.
Secure the bandsaw to the stand with four
M12-1.75 x 25 hex bolts and 12mm flat
washers, as shown in
Figure 13
.
10
. Loosen the belt tension bolt shown in Figure
14
.
Figure 14. Belt tension bolt location.
Belt Tension Bolt
Axle
Wheel
Base
Cotter Pin
Leveling
Feet
(Handwheel Not Yet
Installed)
(Pulley Cover Not
Yet Installed)
Hex Bolts
(2 of 4 Shown)
