Source Audio Vertigo Tremolo, Руководство пользователя, Страница: 20 / 31

SA243 Vertigo Tremolo User’s Guide 20
3. Move the expression pedal over the range of motion you would like to use to control the
Vertigo. If you would like to use the expression pedal’s full range of motion, then make sure
to move the pedal all the way from its minimum position to its maximum position. Note that
you can create “dead zones,” if desired, by only moving the expression pedal over a limited
region of its full range of motion.
4. After setting the expression pedal range, click the Vertigo’s footswitch once. The calibration
is now complete, and the Control LED will blink faster (about 2 blinks per second). Now, it is
time to map the expression pedal to the effect parameters.
5. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the Vertigo’s footswitch. The Control LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the
expression pedal, up to four total knobs.
6. Move the knob(s) you wish to control with the expression pedal to their maximum desired
position, then click the footswitch. The Control LED will now be lit solid green. Note that you
may control one or more knobs with the expression pedal, up to four total knobs.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Note: The parameter range can be inverted by swapping the minimum and maximum position of the
knobs during calibration.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the Vertigo’s Control Input
for motion control of the Vertigo’s effects parameters. The Hot Hand has two axes of expression: X
and Y. These signal are carried on the two rings of the TRRS cable that comes from the Hot Hand
receiver.
Configuring the Hot Hand
When the Hot Hand is connected to the Vertigo, follow these simple steps to calibrate it and map it
to control different effect parameters.
1. Press the Control Input button to turn on Control Input mode. The Control LED should be lit
green.
2. Press and hold the Control Input button until the Control LED begins to blink slowly
(approximately one blink per second).
3. Move the Hot Hand ring over the range of motion you would like to use to control the
Vertigo. The easiest way to do this is to move the ring in the same way that you intend to
Ground Power
Y Exp X Exp