soundsation Zeus II D Series, Руководство пользователя

Страница: 9 / 36

9
ENGLISH
ZEUS II D-series User manual
3)^VENTILATION grille
It allows constant ventilation between the front and back of the amplifier. It is suggest-
ed not to obstruct this grill.
4)^INPUT AND LINK CONNECTORS
Each channel has one balanced female XLR connector, which accepts a XLR plug from
almost any type of equipment with a balanced or unbalanced outputs.
The male LINK connectors are connected in parallel with the respective INPUT, so the
LINK is wired at the same way.
Note: Whenever possible, always use balanced cables. Unbalanced cables can
also be used, but there may be noise problems. In any case, avoid using a
balanced cable for one channel and one unbalanced for the other.
5)^GAIN SENSITIVITY SECTION
This section has three indicators (LED) and a three-positions switch to allow the selec-
tion of the input signal sensitivity of the so that you always have an adequate margin
(Headroom) between the nominal level of a signal and the maximum level that the am-
plifier can handle correctly before saturation occurs with consequent reduction of the
signal. The selector (three-positions switch )allows you to choose, as the input sensitiv-
ity, 26dB (Red LED), 32dB (Green LED) or 1.2V (Orange LED).The positions of the switch
for selecting the gain sensitivity correspond to the positions of the LEDs.
BASS PROCESSING SECTION
This section has two indicators (LED) and a two positions switch. Moving the switch to
the green LED (ON), will increase the bass level influencing the 80Hz/90Hz frequencies
and the green LED will light up. If the switch is in the OFF position (orange LED on),
there is no effect on the audio signal.
6)^OPERATION MODE SECTION
This section has three indicators (LED) and a three positions switch to allow the selec-
tion of BRIDGE, STEREO or PARALLEL operation modes. The positions of the switch for
selecting the operation mode correspond to the positions of the LEDs.