soundsation PMX-4BT, Руководство пользователя

Страница: 12 / 32

12
ENGLISH
PMX-4BT User manual
3.9. Mains and Fuse
POWER
AC INPUT
~
230V 50 hZ
FUSE T2A
250V
1 2
3
(1) Power Cord Make sure the voltage is the same as
indicated on rear panel of the unit (230
Vac/50Hz) and described in the technical
specifications of this manual.
(1) Fuse When replacing the fuse, in order to avoid
the risk of fire and damaging the unit,
please use only the recommended fuse type
as described on the rear panel of the unit
(T2A). Before replacing the fuse, make sure
the device is switched off and unplugged
from the outlet.
(3) Power Switch It switches the unit ON (I) and OFF (O).
3.10. Speaker Outputs
SPEAKERS
L R
4 Ohm
These outputs are connected to passive speakers. Connect
a passive speaker to LEFT output and a second speaker to
RIGHT output. The impedance of each speaker must be
between 4-8 ohms.
WARNING: Minimum total impedance accepted by
the amp stage is 4ohms. If total load is less than
4ohms, you may damage the unit!
4. CABLES AND CONNECTORS
4.1. Mains cable
If you happen to replace the power cord plug, always use a three-pin plug with a
ground pin. The wire correspondence is as follow:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth