Set up
1.
1.Remove all packing materials from the bubble machine.
2.
2.Place buble machine on a flat surface.
3.
3.Loosen the side screws and lift the housing upwards. You will see a
liquid tank.
4.
4.Pour bubble liquid into the liquid tank, being creful not to exceed the
maximum fluid level. DO NOT OVERFILL.
5.
5.When the container is full, Lower the housing and tighten the screws.
Important Safety Notice
Ensure your bubble machine is unplugged from the mains electrical supply
before attempting to open the housing.
To help avoid accidental exposure to dangerous live AC mains voltage,
two safety screws are fitted that require a screwdriver to remove. Once
these are removed, the screws are removed; the finger screws can e undone
by nand.
Once the screws are removed, the lid of the housing can be carefully
swung upwards, as shown above. Take care not to spill any of the bubble
fluid inside the unit.
The fluid tank is designed to fit only one way around. Make sure you insert
it corredtly, as shown above, Take care not to spill any of the bubble fluid
inside the unit.
Never aim the output at open flames.
Position output of bubbles away from persons
Operation
Turn on the power switch located on the back of the bubble machine. You will
notice that the intemal bubble drum and fan are activated. Bubbles are now
produced.
